Plastic (uPVC) wall cladding – surface distortion

Causes

Fault during manufacturing 

Poor/incorrect installation, or thermal expansion not allowed for during installation

Listed under: Exterior, plastic, unplasticised polyvinyl chloride (uPVC), cladding, walls, wall cladding, plastic (uPVC) wall cladding

Cause

Fault during manufacturing 

Repair

  • if within the warranty period, contact the manufacturer to discuss replacement
  • if water enters due to movement, replace the cladding

Back to top

Cause

Poor/incorrect installation, or thermal expansion not allowed for during installation

Repair

  • if within the warranty period, contact the manufacturer to discuss replacement
  • if water enters due to movement, replace the cladding

Back to top