Continuous flow water heating
Showing results 1-7 of 7
Instantaneous or continuous flow water heaters – no hot water
-
No gas supply
-
Pilot flame extinguished
-
No electricity
-
The on/off button was pressed during hot water use
-
Insufficient water flow to start water heating
Instantaneous/continuous flow water heaters – water not hot enough
-
Temperature not set high enough
-
Source water temperature very low
-
Water flow rate too high
-
Low gas flow
Instantaneous/continuous flow water heaters – reduced water flow
-
Inlet filter is blocked
Instantaneous/continuous flow water heaters – fails to ignite
-
No gas supply
-
No electricity supply to ignite the pilot light
Water heaters – unit starts and shuts down immediately
-
No gas supply
-
No electricity supply to ignite the pilot light
Continuous flow gas water heaters – rusting of metal casing, flue
-
Lack of cleaning
-
Insufficient original corrosion protection to steel
-
Very corrosive environment – near the sea or a geothermal area
Continuous flow gas water heaters – rusting of fixings
-
Lack of cleaning
-
Insufficient original corrosion protection to steel
-
Very corrosive environment – near the sea or a geothermal area